Electrical loom removal (rear)

[VFRGirl]

I have linked this from another site im a modmember of. I did this last summer. Took me a while but it was fun doing it. Hope this helps anyone who fancies a shot at it :D

Rear loom removal/replacement (http://bbs.400cc.co.uk/showflat.php?Cat=0&Number=2044&an=0&page=0#2044)

[SpudSon]

Hi

Nice bit of work there, I think this could even be useful to folk with real bikes :D ,

But I'm not sure about the suggestion to “Make sure you put some cloth or loo roll in the carb funnels as you don't want any crap going in them!!” I'd be a wee bit worried about tissue getting into the jets etc.

But I’m being picky here maybe.

David

[VFRGirl]

lol, i used cloth but bits can come off cloth too. As long as you clean any bits out after though it's ok. :D

[Hants_Tiger]

As long as it doesn't rain your fine using tissue, though maybe kitchen towel instead of Loo Roll, but preferably somthing like Kimpwipe (Blue Tissue stuff)

You could place small plastic bags over each and elastic band them there if you wanted too. All depends what you have to hand at the time :D